Honeywell TH8000 Vision Pro Model TH8110U1003

Front Cover

TH8110U1003 Manual & Installation PDF

Back Of Unit 

Model Number

OK here is where I get confused  ON the far Right is for Heat Pump which is what I have 

Payne PH13 AC/  Heat Pump 

Payne PH13 

and also have a Payne 

PF4MNB
DIRECT EXPANSION FAN COIL
FOR R--410A REFRIGERANT
SIZES 019 THRU 061

Payne PF4MNB

Well on The TH8110U1003 Base Plate I would think that it is hooked up as Follows 

(RC) & (R) Linked = Red Wire (24VAC Hot)

O/B (Heat Pump Changeover)  is where I am confused because Orange Wire Goes there on the Heat Pump Side and On the Conventional Side There is a (W) (Heat Relay) which is where the White Wire should go to I believe since White is Heat , So do I hook them both into there ? cause there the same slot

(G) Green Wire (Fan)
(Y) Yellow Wire (Compressor Contactor)
(C) Blue Wire (24VAC Common)

If I got anything Messed up let me know please

Thanks For Reading
&
Thanks in advance if you help

Ok From The Begining

Front Cover

TH3210D1004

Switches Closeup

OK AS IT STANDS WORKING

(E) (Emergency Heat) No Wire (Aux ) (Auxiliary Heat Relay) White Wire (Y) (Compressor Contactor)

Yellow Wire (G) (Fan) Green Wire (O) (Heat Pump Changeover Valve Energized In Cooling) Orange Wire (L) (Heat Pump Reset) No Wire (R) (24VAC HOT) Red Wire (B) (Heat Pump Changeover Valve Energized In Heating) No Wire (C) (24 VAC Common) Blue Wire

Everything Works but I want to install the Honeywell TH8000 Vision Pro (TH811U1003)

Front Cover

TH811U1003  

Next Page